There could be other approaches to Grouping. Grouping can be done based on Location (XenMobile). Right-click Groups and then select Create a new group. Open the SCOM Operations Console and go to Authoring. Type the appropriate values and then click Create to create a Management Pack. Right-click Management Packs and then click Create Management Pack. Open the SCOM Operations Console and go to Administration. The Certification field should be CERTIFIED. Check the Properties of each XenMobile Server. If the discovery is successful, the XenMobile Server nodes appear. To confirm the XenMobile Server nodes are successfully discovered, go to Network Management > Network Devices. Select the Rule and then click Run from Tasks pane. To run the discovery rule manually, go to Network Management > Discovery Rules. After the rule is created, do one of the following:Įither allow the discovery rule to be run after the wizard is closed. This wizard creates a Discovery Rule to discover XenMobile Server nodes.
#Scom snmp trap receiver password
Ensure that you add the correct password and protocols. To create Run As Account for SNMP v3 devices, the user should be the same user you added in the XenMobile console in the SNMP settings. Access mode can be either SNMP or ICMP and SNMP. To discover XenMobile Server nodes, select Network devices.īecause XenMobile Server supports only SNMP V3, select/add SNMP V3 Run As Account. Right-click Network Management and then open Discovery Wizard.
The steps in this article are only examples.Įnable SNMP monitoring in the XenMobile console. Consult a SCOM expert for specific configuration steps. Important: There are various approaches to monitoring in SCOM. To configure SCOM to monitor XenMobile Server nodes and receive traps
0 kommentar(er)
